Autel Robotics X-Star WiFi Drone Firmware 1.1.3
Tipo di file: Firmware.
Sistema Operativo: AnyOS.
Nome del file: X3P_FW_WIFI_V1.1.3.bin.
Bit: 32/64 Bit.
Licenza: Gratis.
Descrizione
Release Notes:
– Enabled waypoints, orbit and follow mode that will work with a new APP version that is going to be released soon
– Added gimbal roll adjustment feature and optimized gimbal parameters
– Fixed clip preview errors and compatibility issues of SD cards
– Improved Starlink Positioning System’s performance by adding angle compensation
– Fixed gimbal lock issues with certain older version of Android/iOS phones
– Fixed other bugs
To update the firmware on your X-Star:
Step 1: Ensure the aircraft battery and remote controller are fully charged. If the battery holds less than a 50% charge, the update might be interrupted.
Step 2: Power down the remote controller and aircraft.
Step 3: Scarica il firmware update file
Step 4: Insert the provided microSD card into an SD Card Reader (not provided) and plug it into your computer.
Step 5: Copy the firmware file to the root directory on the SD card.
Step 6: Power on the remote controller and the aircraft.
Step 7: Watch the LCD display on the remote controller and wait for the remote controller to connect to the aircraft.
Step 8: Insert the microSD card into the camera.
Step 9: Watch the LCD on the remote controller to see the file begin unpacking (which takes 30 to 60 seconds). If unpacking fails, delete the update file from the SD card and start again at Step 1.
Step 10: Periodically check the LCD which shows each component being updated. The update may take up to 30 minutes.
Step 11: After the LCD indicates each update was successful, power off the aircraft and the remote controller to complete the update.
Step 12: If any part of the update fails, power off the aircraft and remote controller and proceed to the next section, to retry the update after a failure.
Download