NETGEAR WNDAP350 Access Point Firmware 3.6.9.0
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: WNDAP350_V3.6.9.0.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
Bug Corrections:
– Fixed VLAN related issues over the WDS link
– Fixed few AP reboot issues when APs are managed through Business Central
– Enhanced logging capabilities in Monitoring -> log page.
– Fixed intermittent data path issues with iPhone 4S and iPads.
– Fixed DST (Day light saving) and Non-DST time period for most of the time zones supported.
– Fixed issue where the WLAN utilization rate through SNMP MIB is not showing properly
Known issues:
– Rogue AP detection table may not list all the neighbor APs immediately
– Time not updated properly in the AP GUI for the time zone Georgia.
– AP reboot required after changing the authentication from WEP to WPA/WPA2-PSK only when WDS is enabled for 2.4GHz and 5GHz radio simultaneously
– Sometimes GUI page takes long time to load when moving between the tabs multiple times and after FW upgrade. Workaround: Refresh the browser page where the page loads immediately.
To Install:
– Download the new software and save it to a convenient folder location.
– Login to the access point web management GUI.
– Take backup of the current configuration and save it at a secure place.
– Select Maintenance > Upgrade > Firmware Upgrade.
– Click Browse and browse to the location of the software upgrade file that you just downloaded.
– Click Apply. The upgrade process typically takes at least 8 minutes.
– Warning: When uploading software to the Wireless Access Point, it is important not to interrupt the Web browser by closing the window, clicking a link, or loading a new page. If the browser is interrupted, the upload might fail, corrupt the software, and render the access point completely inoperable.
– When the upload is completed, your wireless access point automatically restarts.
– If you decide to use the AP as standalone, log into the AP and disable Cloud management.
– If you decide to use the AP in cloud management, factory reset the AP and add the AP to BCWM portal.
Télécharger