Kramer VP-731 Presentation Scaler-Switcher Firmware 1.08 Master
Type de fichier: Firmware.
Système d’exploitation: AnyOS.
Nom de fichier: vp-730_731_master_firmware_upgrade_ver._1.08.zip.
Bit: 32/64 Bit.
Licence: Gratuit.
Description
The following changes were made in this version:
Corrections:
– Error messages were created for large files: “File too big”, and for small files: “File too small”.
– For any input switch command, only one response, the new input, is sent to the RS232/ETHERNET port.
– A 15 sec timeout was canceled so that the unit responds immediately to any new command preceding any command sent from RS232/ETHERNET.
Firmware Upgrade Procedure
1. Acquire xxx.brec file with the required version of firmware.
2. Copy this file to the route directory on any USB readable memory device (disk-on-key, flash memory card etc.).
3. Plug the device with the firmware file into USB connector of the VP728/729 and switch osan the scaler.
4. Wait until the scaler boots up and then use OSD menu to navigate to Setup>Advanced Setup>Misc>Firmware Download
5. Use UP and DOWN arrows to highlight the required firmware file and press ENTER button.
6. Confirm the upgrade and wait until progress indicator gets to 100%.
7. Restart the scaler by recycling the power.
Télécharger