ZyXEL NWA1100-NH Access Point Firmware 2.10(AASI.1)C0
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: NWA1100-NH_V2.10(AASI.1)C0.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Versiones:
Kernel Version : V2.6.31
Firmware version : V2.10(AASI.1)C0
BootModule Version : V1.1.4
Modifications in V210(AASI1)C0
A. New Features
1. IEEE 802.1AB support.
2. https CA import.
3. Native VLAN support.
4. LED suppression support.
5. Increase firmware checksum program.
B. GUI Enhancements
1. Engineering webpage change.
2. Move RADIUS Profile setting from SSID profile into Security Profile.
3. NTP “manual IP” should accept domain name; Change name into “Manual Setting”.
4. VLAN on/off switch in SSID profile.
5. Remove MCS rate selection in advance setting.
6. The new increase in client mode SSID profile.
7. Remove “FCS Error Count” in Statistics page.
C. Bug Fixes
1. Invalid file is acceptable in “firmware upgrade”. It may damage AP and make AP cannot boot up successfully.
2. Can’t upgrade AP firmware through NAT.
3. LAN was set to wrong subnet mask after reconfigure network settings when getting address from DHCP server.
4. “Time for sending log” field does not accept values with leading zero.
5. ZON Utility cannot access device when device has IPv6 enabled and reboot.
6. When webpages upgrade firmware image, sometimes it will cause damaged configuration file.
7. Wireless driver happened oops by FTP stress over night.
8. Fix 2.4G TX power setting.
The following is the firmware upgrade procedure:
1. If user did not backup the configuration file before firmware upgrade, please follow the procedures below:
– Use Browser to login into device as administrator.
– Click Maintenance > Configuration File > Backup to save the current configuration file (config.cfg) of your system to your computer.
– Find firmware in a file that (usually) uses the system model name with the .bin extension”
– Click Maintenance > Firmware Upgrade to open the Firmware Package screen. Browser to the location of firmware package and then click Upload. The device automatically reboots after a successful upload.
– After several minutes, the system is successfully upgraded to newest version.
Descargar