Integra DTR-40.2 A/V Receiver Firmware 1.10
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: ONKAVR0003_MA00MAMAMA00SAM7MA_110.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Cambios:
– Improves the operation when HDMI Through is set to on
– Stabilizes the operation of Network Control
Notes:
– Make sure the AV receiver and TV are turned on.
– Never unplug or turn off the AV receiver during updating process.
– Never plug or unplug an HDMI cable during updating process.
– Never unplug the USB storage device containing the firmware file and the AC power cord during updating process.
– Do not access the AV receiver from PC during updating process.
– It will take about 30 minutes to update the firmware.
– The AV receiver will retain all your settings after update is finished.
Before you start:
– Check HDMI Control (RIHD) setting. The update may not be successful if this setting is on.
– Turn off the controller device connected via RS232C and via Ethernet network.
– Turn off Zone 2 and Zone 3.
– Stop playback of content from Internet radio, iPod,
– USB or servers, etc.
Update Procedure via USB:
– Connect a USB storage device to your PC. If there is any data in the USB storage, remove it.
– Descargue el firmware file and unzip it.
– Copy the extracted files to the USB storage device. Be careful not to copy the zip file.
– Remove the USB storage device from your PC and connect it to the USB port on the AV receiver/controller.
– When the AV receiver/controller has two USB ports, you can use either one.
– Make sure your AV receiver/controller and TV are turned on.
– If the AV receiver/controller is in standby mode, push [ON/STANDBY] to light up the front display.
– Select the USB input source. “Now Initializing” is displayed on the front display and then the name of the USB storage device is displayed. It will take 20 to 30 seconds to recognize the USB storage device.
– Push [RECEIVER] followed by [SETUP] on the remote controller.
– Main menu will be displayed on TV screen.
– Procedures thereafter can also be performed on the AV receiver/controller by using its SETUP, arrow, and ENTER buttons.
– Go to “Hardware Setup” menu.
– Go to “7-7. Firmware Update” menu.
– Select “Via USB” and push [ENTER].
– Select “Update” and push [ENTER].
– Updating will begin.
– As the updating progresses, the TV screen may disappear depending on the program updated. In this case, you can see the update progress on the front display of the AV receiver/controller. The TV screen will reappear when you finish the update and turn on the AV receiver/controller.
– Do not turn off the AV receiver/controller and do not remove the USB storage device during updating process.
– Message “Complete!” appears on the front display of the AV receiver, indicating that the update has been completed
– Using the [ON/STANDBY] button on the front panel, turn off the AV receiver/controller and then remove the USB storage device.
– Do not use the ON or STANDBY button on the remote controller.
– Push ON/STANDBY to turn on the AV receiver/controller.
– Congratulations!! Now you have the latest firmware on your Onkyo AV receiver/controller.
Descargar