Fractal Audio Axe-Fx II Mark II Preamplifier Firmware 18.01
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: axefx2_18p01.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
This firmware incorporates all-new amp modeling algorithms:
– With this update the Axe-Fx II now incorporates our “Generation 3 (G3) Amp Modeling Technology”.
– G3 modeling improves upon our previous modeling with better touch sensitivity, better dynamics, better distortion texture (or “grain”) with less fizz, more crunch and improved frequency response accuracy.
– Not all amp models have been fully converted to take advantage of G3 modeling as of this release.
– Those that have been fully ported are indicated by “(G3)” after the model name on the Pre page of the Amp block.
– Those that have not been fully ported yet will still benefit from the improved algorithms.
The Rotary block has been completely revised:
– It is recommended to reset the block in any existing presets by double-clicking the Bypass button to load the default values.
– Also, the Rotary block now supports X/Y which simplifies slow/fast switching.
Added USB Return Level parameter to I/O->Audio menu:
– This parameter sets the level of the USB input sent to the main outputs.
Added “Word Clock” parameter to I/O->Audio menu:
– This selects the clock source for the A/D and D/A converters.
– Auto: uses the internal clock if the input source is Analog or USB. Uses the recovered SPDIF/AES clock if the input is SPDIF/AES.
– SPDIF/AES IN: uses the recovered clock for all input sources. A valid 48 kHz data stream must be present at the AES or SPDIF input. If a valid stream is not detected the unit will fall back to the internal clock and display “NO INPUT CLOCK!”. The SPDIF/AES select must be set to the appropriate value, i.e. if the data stream is input to the XLR jack then SPDIF/AES SELECT must be set to AES.
Other Changes:
– Added modifier capability to Compressor block Level control
– Replaced some of the factory IRs with UltraRes IRs from our upcoming Universal Noise Storage 2 Cabinet Pack. These IRs are the first IRs that we have captured using the “Mic + DI” technique which results in IRs with improved accuracy and clarity.
– Fixed Cabinet block room simulation collapsing to mono if Mode is mono and Preamp Type is not None.
NOTA:
– It is possible that the new Word Clock parameter (see below) will be set to SPDIF/AES IN after installation of this firmware. This will result in a “NO INPUT CLOCK!” message appearing on the screen. If so, set the Word Clock value to “Auto” in the I/O->Audio menu.
– The USB Return Level parameter will be uninitialized after installation of this firmware. Set the desired USB Return Level via the I/O->Audio menu.
Descargar