Cisco RV130W Router Firmware 1.0.0.21
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: RV130X_FW_1.0.0.21.bin.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Caveats Acknowledged in Firmware Version1.0.0.21:
– Problem: If users set outbound firewall access rules to Deny, then create an Internet access policy to permit a specific website, the access rule does not work and other websites are also permitted. (CSCun04513)
– Solution: None.
– Problem: If users enable Email settings, set Authentication with SMTP Server to Login and enter a secondary email address to which to send logs, email is not sent to the secondary address provided. (CSCum76056)
– Solution: Disable the Login authentication option.
– Problem: STP does not work accurately with Link Aggregation Groups (LAG). For example, if ports 1 and 2 are included in a LAG, the STP root bridge is wrong after the link status changes for port 1. (CSCum50055)
– Solution: Disable LAG.
– Problem: The WDS links is not up if the peer MAC address format is incorrect. For example, users enter 001122334455 instead of 00:11:22:33:44:55. (CSCum59546)
– Solution: Change the MAC address format to ‘00:11:22:33:44:55’.
– Problem: Wireless clients may not be able to access the Internet when roaming between the device and another access point on the LAN side. (CSCum42666)
– Solution: Enable WAN QoS or STP on LAN ports.
– Problem: When the syslogs reach 1000, the device does not email logs to users. (CSCum72888)
– Solution: Use the syslogs server to view the messages or check local syslogs.
– Problem: VLAN ID 80 does not work. (CSCum31734)
– Solution: Use other VLAN IDs.
– Problem: If the PPTP tunnel is established and users create a new VLAN, the PPTP clients are offline and cannot connect again. (CSCum72910)
– Solution: Go to the PPTP Settings page and save again.
– Problem: If Dead Peer Detection is enabled, the IPsec VPN tunnel may reconnect in case of heavy traffic. (CSCum72973)
– Solution: Limit heavy traffic over the VPN tunnel.
Procedimiento de instalación:
– Guarde el paquete descargable.
– Inicie sesión en la interfaz de usuario web del enrutador.
– Navegue a la sección de actualización de firmware de su unidad inalámbrica.
– Seleccione el firmware actual y configure su enrutador para instalar este archivo.
– Espere a que el dispositivo realice este proceso.
– Reinicie la unidad si es necesario.
Descargar