Cisco RV016 Router Firmware 4.2.3.03
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: RV0XX-v4.2.3.03-20140319-code.bin.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
New Features:
– Email account authentication is configurable for email alert.
– The private IP address of the client and NAT-T are now supported on IPsec QuickVPN.
– For network service detection, the recovery back timer is configurable if the primary WAN is up again after failover.
– Compatibilidad con IPv6 stateless address autoconfiguration for a WAN connection.
– ProtectLink tab is removed from the GUI.
Resolved Issues:
– The maximum data transfer rate for HTTP traffic on RV042G is approximately 150 Mbps.
– The routers cannot set up the VPN connection and cannot be accessed through its web-based Configuration Utility after running for a long time with email logs enabled.
– No log message is displayed when you select All from the Filter drop-down list.
– The site-to-site VPN connection cannot be up again if you configured multiple VPN tunnels with different remote subnets.
– The Connect on Demand function cannot work when there are multiple subnets.
– The subnet IP address of the DMZ port can access the port forwarding host.
– The gateway-to-gateway IPsec tunnel cannot reconnect after any of the routers restarted if IP by DNS Resolved and Tunnel Backup were configured.
– Sometimes the IPsec VPN connection will be disconnected when the Quick VPN tunnel though the Internet is disconnected.
– In RV016, the Client Lease Time field on the DHCP Setup page displays 1440 minutes, but is set to 5 minutes by default.
– Choosing the Connect on Demand option when configuring PPPoE as the WAN Connection type, the IPv6 PPP daemon.
Procedimiento de instalación:
– Guarde el paquete descargable.
– Inicie sesión en la interfaz de usuario web del enrutador.
– Navegue a la sección de actualización de firmware de su unidad inalámbrica.
– Seleccione el firmware actual y configure su enrutador para instalar este archivo.
– Espere a que el dispositivo realice este proceso.
– Reinicie la unidad si es necesario.
Descargar