Atomos Ninja V Recorder Firmware 10.56
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: ATOMNJV_10.56.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Correcciones:
– Fixed an issue where 3D LUTs would not display correctly when switching between playback and record mode, or when restarting the Ninja.
RAW recording from Olympus OM-D E-M1X and OM-D E-M1 Mark III
– Compatibilidad con Olympus OM-D cameras for 12-bit RAW out over HDMI. For E-M1X, Camera Firmware version 2.0 is needed and for E-M1 Mark III Camera Firmware version 1.2 is needed.
– 12-bit ProRes RAW Recording: 4K DCI (4096 x 2160p at 24fps), 4K UHD (3840 x 2160p at 23.98, 25, 29.97 fps).
– AtomOS RAW Monitoring Settings: Native – Linear to Log gamma or use with 3D LUTs – can use any existing Log gamma LOOK LUTs; Rec709 – to view RAW input in SDR up to 6.7 stops of dynamic range; HLG – to view RAW in HLG with up 10.5 stops of dynamic range; PQ – to view RAW in PQ/HDR10 with up to 10.5 stops of dynamic range, for scenes with extended spectral highlights.
– AtomOS Non – RAW Monitoring Settings: Monitor OM-Log400 gamma in DCI-P3 D65 colour space; Monitor Olympus flat gamma in Rec709 colour space
Known limitations:
– The Ninja V monitor display colour balance changes momentarily when the camera ISO speed is changed from 400 to 500. The issue is only observed in REC mode and DOES NOT affect the recorded clips.
– RAW to HDR HDMI output – PQ / HDR10 output conversion may appear slightly darker by 1-2 stops.
– Camera Triggers and Timecode are not available when outputting RAW from the E-M1X and EM1 Mark IIII. Use rec run or time of day on the NinjaV timecode settings page.
– Timecode recorded internally on the camera and externally on the NinjaV may not be frame accurate for non-RAW video.
Firmware Update Tutorial:
– Download and unzip the file.
– Copy the file onto a recommended, formatted driver, using the docking station included with your recorder.
– Insert the drive into the Atomos recorder while it’s off.
– Power up the Atomos recorder.
– The screen will show flashing lines of color. This is normal – DO NOT power off!
– Updating will take a few minutes.
– Once completed, the Atomos recorder will power down.
– Power up the Atomos recorder again.
– Check Menu > Product Info > AtomOS Version. This should match the version you have just downloaded.
– Enjoy your updated Atomos recorder !
Firmware Recovery Tutorial:
– Power down the Atomos recorder (Hold power button for 4 seconds).
– Hold down the power button for 10 seconds approximately.
– You will see the “Firmware Update Failed” screen.
– Insert your HDD / SSD.
– The install process will begin and the screen will show flashing lines of color. This is normal – DO NOT power off !
– Once completed, the Atomos recorder will power down.
– Enjoy your updated Atomos recorder !
Descargar