Alcorn REPRO24D Binloop Reproducer Firmware 1.81
Tipo de archivo: Firmware.
Sistema Operativo: AnyOS.
Nombre del archivo: reprov181.zip.
Bit: 32/64 Bit.
Licencia: Gratuito.
Descripción
Release Notes:
– Improved Synchronous Play reaction time when CF card contains large number of files (200+)
– Fixed issue that would cause the CF scanning process to take a long time (5+ seconds) when there are many files on the CF Card. This issue would prolong bootup and also delay the system from being ready after how-swap insertion of a CF card.
Instrucciones de instalación:
1. Copy OS.NEW to the Compact Flash card.
2. Reset unit by turning it off, and then on again.
3. Wait for Update to complete. You will see the following LED sequence:
VERIFY FILE – Solid GREEN LED
ERASING FLASH – Solid RED LED
PROGRAMMING FLASH – Solid ORANGE LED
4. The firmware version on the reproducer can be read using the diagnostic version request in Binloop.exe.
NOTE: When the update is complete, the OS.NEW file will be renamed to OS.SAV so that the update does not repeat when the hardware is powered-up again. If you want to use a single flash card to update multiple units (for example, an entire Binloop cage), you can change the name of the OS.NEW file to FACTORY.NEW. The FACTORY.NEW file will perform an update just like OS.NEW, only it will not be renamed at the end of the update process. This means that after an update, you can remove the flash card from the product and insert it into another product to perform another update. This method will allow you to update an entire Binloop cage using a single card, without powering down the cage.
Descargar