Ubiquiti UAP-LR v2 Access Point Firmware 3.9.15.8011
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: BZ.qca9342.v3.9.15.8011.171208.1655.bin.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Firmware changes since 3.9.3/3.9.6:
– [UAPG3] Minimum rate fixes.
– [UAPG3] Further improvements to device upgrade and boot times.
– [UAPG3] Fix a crash in hostapd when Fast Roaming is enabled.
– [UAPG3] Add support for 802.11r and 802.11k.
– [UAPG3] Fix channel utilization reports.
– [UAPG3] Improve bootup and TFTP recovery times.
– [UAPG2/G3] Add RADIUS VLAN support to MAC authentication bypass.
– [UAPG2/G3] Fix a bug which prevented APs from upgrading when bandsteering was enabled.
– [UAPG2/3] Fix crash reported HERE.
– [UAPG1/G2] Add net-snmp.
– [UAPG2] Add support for 802.11k.
– [AC-IW/IW-Pro/Pro/EDU/M-Pro] Fix VLAN passthrough regression.
– [AC-IW/IW-Pro/Pro/EDU/M-Pro] Add port disable support.
– [AC-IW/IW-Pro] Improve VLAN config, and prevent traffic leaks.
– [AC-IW/IW-Pro] Fix RADIUS VLAN when port VLAN is enabled.
– [AC-IW/IW-Pro] Add QoS CIR/EIR support.
– [AC-IW/IW-Pro] Performance improvements.
– [AC-IW/IW-Pro] Fix management VLAN issue causing decreased multicast performance.
– [XG] Fix airView and airTime support.
– [nanoHD] Add stainfo support.
– [EDU] Fix the issue with volume not applying (reported HERE).
– [EDU] Improve baresip config script.
– [UAP] Fix a small memory leak.
– [UAP] Fix outdoor flag.
– [UAP] Add fast-apply for guest portal.
– [UAP] Improve guest portal redirector handling.
– [UAP] Fix a bug with L3 wireless adoption.
– [UAP] Fix bandsteering.
– [UAP] Fix bridge priority so the secondary Ethernet port remains enabled (reported HERE).
– [UAP] DFS improvements.
– [UAP] Fix an issue preventing bandsteering from being enabled.
– [UAP] Fix an issue with the downlink monitor.
– [UAP] Add uplink prioriy for the bridge interfaces.
– [UAP] KRACK AP mode patches for 802.11r.
– [UAP] Various bugfixes and improvements.
– [USW] Add port ID in STP error message.
– [USW] Lower STP topology change log level.
– [USW] Improvements to DHCP guarding and snooping.
– [USW] Add DHCP snooping debug command.
– [USL2] Improve PSU status reporting.
– [USXG] Improve LAG config handling.
– [HW] Security improvement.
– [HW] Update openssl package to 1.0.2m.
– [HW] Update curl to 7.57.0.
– [HW] Add IPv6 management support.
– [HW] Improve event notification on device upgrade.
– [SEC] Fix CVE-2017-14106.
Download