Buffalo TS3200D NAS Firmware 1.60
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: ts3000-v160.zip.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Added and Modified Features:
– [iSCSI]: – Modified to display clients connecting to the volumes when displaying the connection history. You can see it by navigating to ‘Drives’ – ‘iSCSI’ and click ‘Show Active Connections’ on Settings.
Bug Fixes:
– [Amazon S3] Fixed a bug where while on the AWS Management Console, renamed or uploaded files did not appear on the TeraStations.
– [Amazon S3] Fixed a bug where Amazon S3 did not work if drive 1 fails while Amazon S3 was enabled.
– [Others] Fixed a bug where an error message was displayed when accessing the shared folder settings for a shared folder that has access restrictions enabled for local users.
Caution:
– Please consult your local technical support representative if you experience any problems caused by this firmware update.
– Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
– USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.
How to Use the Updater:
1. Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
For example, if the IP address and subnet mask of the computer are
” 192.168.0.10 , 255.255.255.0 “
and the IP address and subnet mask of the TeraStation are
” 192.168.1.150 , 255.255.255.0 “
then the updater will _not_ work properly.
In this case, reconfigure the TeraStation’s IP address and subnet mask to
” 192.168.0.150 , 255.255.255.0 “.
Then they will be on the same subnet and the updater will work properly.
2. Close all applications. Also, stop or exit any firewall software.
3. Extract the downloaded file and run “TSUpdater.exe”. When a TeraStation is detected, an update window will open.
4. Select the TeraStation to update if multiple TeraStation are connected.
5. Click “Update” and enter the TeraStation’s admin password.
6. Click “OK”.
7. Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
8. When the update finishes, a message will be displayed.
Download