AXIS 205 Network Camera Firmware 4.05.1
Dateityp: Firmware.
Betriebssystem: AnyOS.
Dateiname: 205_405.bin.
Bit: 32/64 Bit.
Lizenz: Kostenlos.
Beschreibung
Features:
– Features:
– Small, compact size
– Motion JPEG image quality
– Built-in Web server
– Three different resolutions, up to 640×480
– Up to 30 frames/second in all resolution modes
– Supports up to 20 users simultaneously
– Easy setup using the new one-click installation method or the Windows-based AXIS IP Utility software
– Password-protection option to restrict viewing
Manual Installation with ARP/Ping
The device can alternatively be installed using the ARP and Ping commands.
1. Acquire an unused IP address for the camera. This IP address must be on the same subnet as your computer.
2. Locate the serial number (S/N) on the camera’s rear label.
3. From a computer on your network, open a Command Prompt (in Windows: from the Start menu, select Run… and type cmd in the field. Click OK).
4. As appropriate for your operating system, enter the following commands:
Windows syntax: Windows example:
arp -s <IP Address> <Serial Number>
ping -l 408 -t <IP Address>
UNIX/Linux/Mac syntax: UNIX/Linux/Mac example:
arp -s <IP Address> <Serial Number> temp
ping -s 408 <IP Address>
5. Check that the network cable is connected. Start/restart the camera by disconnecting and reconnecting the power cable.
6. Close the Command prompt when you see ‘Reply from 192.168.0.125: …’
7. The IP address has been set when the Power indicator is permanently lit and the Network indicator flashes intermittently.
8. Start your browser, enter the IP address of the camera in the Location/Address field and press Enter on your keyboard.
Caution!
The firmware upgrade may take up to ten minutes to finish and must not be interrupted.
Download